Pages

Sunday, December 29, 2013

Clean Water

I've had a remnant of last summer's Alaska trip that I finally got around to fixing. Somewhere along the way, the strap that retains the outer rear corner of the fresh water tank pulled out of the floor.

Since I was going to pull out the curbside seat to replace the retaining straps I figured now was the time to install a cleanout port in the water tank as well. I ordered a JR Products 5" deck plate from Amazon for the project.

The tank was previously drained of as much water as possible. As usual, I used my small trim router to cut the hole for the retainer. The tank was soft enough that I likely could have used a knife instead which wouldn't have made as much mess in the tank.

Stainless steel panhead screws with lock washers and plain nuts were used to attach the ring to the tank. 3M5200 sealant was used under the rim of the ring with a dab on each screw as well.

I double-checked each screw to insure there was some sealant on the threads which will keep the nuts from backing off due to vibration.

The lid has an o-ring on it and screws into the ring to make a waterproof cover. Now it is possible to clean the inside of the potable water tank should it be needed.

6 comments:

  1. Just curious... is this in an RV? I'm always interested to see portable water purification / storage solutions since my company is building this type of equipment for disaster responders. It's been on my bucket list to drive as far north in Alaska... one day hopefully :) All the best, Steve

    ReplyDelete
    Replies
    1. Steve - yes, this is in an RV. See the link at the top of the blog for more information on our Scamp 19.

      Delete
  2. Great job, as usual. As the top of our water tank isn't easy to access, I'm going to just pour in the bleach every few months, and hopefully purify whatever crud is in the tank. Ignorance is bliss, right? Happy New Year ot you and BJ.....jc

    ReplyDelete
    Replies
    1. While I've heard a lot of people having heartburn over the cleanliness of the tank and some that don't use it as all, I've been more in the "ignore it" camp. The access plate went in because it was easy to do while fixing the tank retention design. I was pleased to note that the inside of the tank was spotless!

      Delete
  3. Replies
    1. Thanks, Bob. Not sure it's necessary but it was easy to do.

      Delete